Sweet Moses! Just joined the AR Club

Crossbones

Regular
EE Expired
Rating - 100%
1   0   0
First off, I would like to thank Fabsports and Questar for all their help in bringing this project to fruition. Now on to the good stuff...

DSC02545.jpg



DSC02546.jpg



DSC02548.jpg



DSC02549.jpg



DSC02550.jpg



DSC02551.jpg



DSC02552.jpg



DSC02553.jpg



DSC02554.jpg



DSC02555.jpg





When I first picked up the shorty, I forgot what an AR felt like in my hands. The last time I had touched one was a few years ago when I used the C7. But it felt familiar again once I started handling her.
This rifle started life as a 10.5" RRA A4 pistol and I had the following put on her:

-PWS CQB Compensator

-Magpul MBUS front and back sight

-Magpul CTR stock (commercial)

-Yankee Hill Specter length Diamond forearm

-Yankee Hill fore end cap

-Spike’s Tactical trigger guard

-Yankee Hill Specter Low Profile Gas Block

-BCM Mod 3 charging handle

-ERGO grip

-Troy sling adapter

When I figure out which red dot or scope to get I'll post additional pictures.
 
I love it! Nice charging handle!

Im taking mine out shooting today, first time. Hope it all goes well since I put it all together myself.
 
Thanks for the compliments :D It's good to own one, now the collection is somewhat complete. All I'm missing is a Norinco M305B from Marstar and a revolver and I should be good to go.
My whole setup ran me about $2800 after taxes. Not too bad, since I had all that stuff added on to it. Maybe down the road I'll switch out the trigger set and buffer but until then I'm going to run her hard at the range.
 
DSC02556.jpg


I got a Vortex SPARC for my AR-15 but somehow it doesn't aesthetically go with the lines of the AR. I'll have to decide on another scope (maybe a Vortex Viper PST 1-4X24?). I'm open to suggestions if there are any. Thanks.
 
Back
Top Bottom