Swiss Arms - question about swapping furniture

UncleWalther

UncleWalther

CGN frequent flyer
Rating - 100%
241   0   0
Location
Alberta
I am going to swap out the green furniture, on my Swiss carbine, for black furniture. I see the stock is held in place by some sort of pin. To remove the stock, do I simply drift out the pin with a punch? It looks as easy as that, but I want to make sure I am not missing some step, before taking a hammer and punch to my $3000 rifle :D

Thanks!
 
Yes just punch it out also if I remember there was a flat washer inbetween on one side, just take note of the side it was on for reinstalling
 
Last edited:
Yep. I bought the rifle, new, from TSE a few weeks ago. Green furniture was on the rifle already, and then I bought a complete set of new black furniture at the same time. The black is going to go better with the B&T quad rail I installed.

juliet lima said:
This may be a dumb question but do you already have the black furniture.

jl
Click to expand...
 
koalorka said:
What kind of rail did you get for the Carbine?
Click to expand...

Thanks for the advice guys. The swap is done. The only minor issue was a small washer between the pin and the stock, I assume to ensure tightness of fit. Getting that little washer back in place was tough, but I got it in the end.

Green furniture is now in the EE (stock, grip, forend, and cheek riser).

Koalorka... I picked up a B&T quad rail from Wolverine Supplies. $650.
 
Last edited:
pics:

IMG_0997.jpg


IMG_1005.jpg


IMG_1003.jpg


IMG_1002.jpg
 
God I hate you...


Now I have to upgrade mine. Dude, its tax time too.

Seriously though. Looks great. Missing your G36 yet?
 
You must log in or register to reply here.
Back
Top Bottom