Swiss arms / SAN rifles FAQ
- Thread starter wildphil24
- Start date
swiss baby for xmas
Is that a Neit or NEA rail? Looks high for a B&T.
If you use a B&T and get that Aimpoint out toward the end of the rail and use a low mount, you should be able to co-witness the sights in the lower 1/3rd of your Aimpoint. The front sight hood gets muddled up in that sight picture, but if you shoot both eyes open it ghosts out and isn't a big deal. The alternative is getting a front foldable sight without the hood.
Anyhow, food for thought if you are looking to get that optic lower and workable with that stock.
its a browe 4x sight not an aimpoint, the front sight disappears.
Quick tip for a cheap cheek piece.
Get one of the high AR-15 cheek pieces that snap onto the stock. You can make it fit on the PE90 with a bit of rubber mat material and a zip tie. Its quite sturdy and does not move once in place.
Not a great photo but I think you can see what I did here
Get one of the high AR-15 cheek pieces that snap onto the stock. You can make it fit on the PE90 with a bit of rubber mat material and a zip tie. Its quite sturdy and does not move once in place.
Not a great photo but I think you can see what I did here
Last edited:
lucsergerie
Regular
- Location
- Laurentide,Qc
delete sorry 
Last edited:
I was just wondering the same thing about stripper clips and guides for these?
I was cleaning out various odds and ends from a storage closet and found what I think is a match/target trigger kit for Swiss Arms. Can’t recall who was importing them back in the day, but can anyone confirm these would have been factory kits and not aftermarket? I think I got this in 2009.
Last edited:
