Taurus pt99 parts interchangeable with beretta 92fs??

[Lobster_pot]

Are Taurus pt99af parts interchangeable with beretta 92fs?? Specifically the slides? Thanks for any help

 

[MasterMC]

I believe there is a list posted on taurusarmed forum.

Here you go;

------------------------------------------

Repost from Taurusarmed Forum

Confirmed Beretta 92FS / Taurus PT92 Compatibility Chart 2.0

Compatible:
Barrel & Locking Block Assembly
Guide Rod & Recoil Spring
Take Down Button Spring
Take Down Lever
Slide Stop/Release, & Spring
Trigger Return Spring
Hammer Spring
Grip Frame Bushings
Most likely all springs



Not Compatible:
Trigger( newer Beretta triggers should work but are to long at the bottom and must be shortened. I believe the older Beretta 92-S model has the shorter but more curved trigger like the Taurus but would be hard to find as they are from the 70's)
Hammer(too wide, the original 1975 92 with frame safety or the 1976 92S(second gen.) MIGHT work but once again the parts would be hard to procure. You could possibly mill the right side that sticks out to far on a Beretta hammer flat.)
Take Down Button (Taurus reversed it flipping the side that holds the spring)
Magazine Catch/Release
Grips & Screws(You can use the Beretta grip screws if you install 3 more bushings into the larger holes that don't have one.)


Unknown: but likely
Extractor claw, Pin, & Spring
Trigger Bar & Spring
Firing-Pin Assembly
Hammer Strut
Trigger Pin
Ejector & Pins
Sear, Pin, & Spring
Hammer Spring Plug


Convertible:

Magazines catch notch.
This magazine is dual cut to work with the Beretta and Taurus and shows the correlation between the two.

You could also file the part inside the frame that catches the magazine skinnier so that it will fit Beretta magazines only.

Grip Screws.
Beretta grip screws will work on PT92's if you install 3 more grip bushings into the 3 larger holes in the frame. You still have to use PT92 grips.

---------------------------------------------