Tavor barrel wrenches?

Armedsask

Armedsask

CGN Ultra frequent flyer
Rating - 100%
46   0   0
Location
Saskatchewan
What are you guys doing for a barrel wrench on your Tavors? Is anyone offering these for purchase on their own?

I whipped one up today from stainless, should I hammer out some more?
 
I made it out of 303 stainless, CNC milled. Then bent 90 degrees. Actually looks pretty sharp.

Might make a few more. So CANAM doesn't sell any?
 
I hammered out a barrel wrench in about 15 minutes, and I made a perfectly functional sling adapter in about the same time. I'm hoping you'll start making Tavor stuff that we can't make on our own.
 
I'd be interested. I'm using allen keys right now but they're not very stable and most aren't long enough to provide enough leverage for the purpose. I also don't have the equipment or raw materials necessary to make my own...
 
Armedsask said:
Like what? Give me ideas.
Click to expand...

I want a QD rail riser so I can switch from an Aimpoint to a telescopic sight, and I want a picatinny adapter for the rear optics mount. Most of all I want a bayonet lug like the ones the Indian Tavors have. I bet you could fab up stuff like this better than I could.
 
shmelmafinga said:
I want a QD rail riser so I can switch from an Aimpoint to a telescopic sight, and I want a picatinny adapter for the rear optics mount. Most of all I want a bayonet lug like the ones the Indian Tavors have. I bet you could fab up stuff like this better than I could.
Click to expand...
The picatinny adapter for the rear optic mount is already on my mind. My plan was to use that area for an magnifier and run an Eotech on the barrel mount.

As for QD mount, there already lots of options out there.

I'll go have a look at the Indian bayo mounts.
 
You must log in or register to reply here.
Back
Top Bottom