Tavor Brass

[jdx23]

Curious if anyone is loading 223 brass with the Tavor dent in the side. Currently getting set up to load 223, primarily for AR but I'm wondering if brass from my Tavor is worth saving.

 

[flange]

Reloaded a ton of these from my sons Tavor. No problems whatsoever.

 

[Auggie Doggie]

Ditto. They reload fine. As an aside, I used a piece of 3M 300LSE adhesive to fasten a small piece of bicycle inner tube onto the Tavor's case deflector. No more dents.

Auggie D.

 

[jdx23]

Ditto. They reload fine. As an aside, I used a piece of 3M 300LSE adhesive to fasten a small piece of bicycle inner tube onto the Tavor's case deflector. No more dents.

Auggie D.

Was thinking of attaching a little piece of a velcro adhesive strip. Little rubber pad sounds even better.

Appreciate the feedback everyone

 

[IvoB]

Once you shoot them the case will fire form = no dent

 

[Gatehouse]

Ditto. They reload fine. As an aside, I used a piece of 3M 300LSE adhesive to fasten a small piece of bicycle inner tube onto the Tavor's case deflector. No more dents.

Auggie D.

How about a pic?

 

[jdx23]

Once you shoot them the case will fire form = no dent

Good to know. My concern was that the dent, however small, would raise the pressure in the reloaded case. Or split at the dent when fired.

 

[Rusyl]

The dent came out quite nicely when small base resizing for me. As for fire forming the dent out...it would obviously add another once ejecting.

 

[Auggie Doggie]

How about a pic?

Auggie D.