The Bayonet And Contemporary Rifles
- Thread starter joe6167
- Start date
You don't, it seems. Pretty sure the IWI US barrels no longer include bayonet lugs.
Nightstalker
CGN Regular
- Location
- KaH-NaH-Da
This company makes Lugs, (caveat> haven't bought one)
https://cogburnarsenal.com/product/two-part-clamp-on-bayonet-lug/
https://cogburnarsenal.com/product/two-part-clamp-on-bayonet-lug/
More's the pity. It seems that no Canadian vendors any longer stock the 2-piece Bayonet Lugs. They are great - they fit the OG Famae rifles, the X95, and others with the correct Barrel profile.
Last edited:
TV-PressPass
CGN Ultra frequent flyer
- Location
- Mountains, Alberta
I'd like to see more bayonets of the "sword length" variety made available.
Obviously, if the rifle is too short to make a "proper spear" by whoever's standards: you need to lengthen the bayonet to make up the difference!
Obviously, if the rifle is too short to make a "proper spear" by whoever's standards: you need to lengthen the bayonet to make up the difference!
I'd like to see more bayonets of the "sword length" variety made available.
Obviously, if the rifle is too short to make a "proper spear" by whoever's standards: you need to lengthen the bayonet to make up the difference!
On a bullpup! Gold! The reason for the sword bayonet was to address Calvary (though, I don't believe Lancers).
Q: are the two piece bayonet mounts solid enough? Without a relief cut in the barrel, would it not just slide down the barrel if something hard is struck?
The reason for the sword bayonet was to address Calvary (though, I don't believe Lancers).
Q: are the two piece bayonet mounts solid enough? Without a relief cut in the barrel, would it not just slide down the barrel if something hard is struck?
A properly-fit 2-piece bayonet mount isn't sliding anywhere anytime soon! Relief cut or none....
Ahhhhhhh, good to know!!
I'd like to see more bayonets of the "sword length" variety made available.
Obviously, if the rifle is too short to make a "proper spear" by whoever's standards: you need to lengthen the bayonet to make up the difference!
Mossberg should issue them with the 590A1. While it's totally awesome that they even have a bayonet lug, the AR Bayonets just don't have the right proportions that you get with a proper Trench Shotgun!
You're doing it wrong, Mark.
Reference:
X95 CPRF assault rifle configuration with bayonet
You're doing it wrong, Mark.
Reference:
X95 CPRF assault rifle configuration with bayonet
Awesome - Am I to infer that you have a source for such a Hybrid Flash-Hider/Bayonet Mount and the special Bayonet to go with it? I will gladly switch over if you provide the unobtanium parts....
You guessed unobtanium right!
You're doing it wrong, Mark.
Reference:
X95 CPRF assault rifle configuration with bayonet
not sure which one will break first, the cantilever mount or the handguard? or the gun?
Does anyone know a good quality low profile Picatinny extension?
Interesting… these mounts must have been made of vibranium to resist bending and shear forces involved, unless they are single use only OR decorative, lol
