Think I got's me a 7.5 x 55 but............

diopter said:
Google or search on the Swiss Rifle Forums(s) for:
Santa Fe Swiss Alpine Sporters, Santa Fe was a division of Golden State Arms Corp.

smsantafeadd.jpg
Click to expand...

I finally found the magazine where that ad came from and also found it on EBAY, so I now own it. Thank You!
I also picked up a couple Swiss cleaning kit's with the Automatenfett.
Now how much Automatenfett does a person use to lube the bolt of this rifle?
 
I would put a dab of the Automattenfett into each Locking Recess so that the lugs on the Locking Sleeve have something to cushion them from metal-to-metal contact when you fire it.

Also, It would be a good idea to be sure that the rotating Locking Sleeve also has something between it and the non-rotating Bolt Shank.

Another good place would b in the Unlocking Cam Groove in the rotating Bolt Sleeve, again to reduce metal-to-metal friction.

I think if you have the Fett there, anything else should do with a very light wipe of light oil.

But you will have GOT the high-stress and high-friction areas.

Hope this helps.
 
Smellie has it right.
I would leave a thin laver all over it by rubbing in the grease with a patch.
That bolt has seen some neglect over the years and you need to soften up the crud and rust spots.
Leave it on until you need to fire it and then do as smellie said.

It's amazing how well Automatenfett helps the metal.
try it over any spot where the blueing is thinning out a bit.
 
i have a swiss converted as well to 308 cal..........the front site was bubba improved / screwed but it shoots fine/ accurate with factory / military ammo .
BUT
it wont eject my reloads its always a hard extraction after i fired them ( i stopped after 5 rounds) but works fine with factory .

my same reloads work fine in my isreali k98 and m-305.

any idea why she mite like new but not used ammo??
 
NB.nagantsniper said:
i have a swiss converted as well to 308 cal..........the front site was bubba improved / screwed but it shoots fine/ accurate with factory / military ammo .
BUT
it wont eject my reloads its always a hard extraction after i fired them ( i stopped after 5 rounds) but works fine with factory .

my same reloads work fine in my isreali k98 and m-305.

any idea why she mite like new but not used ammo??
Click to expand...

Got any pic's of it?
 
You must log in or register to reply here.
Back
Top Bottom