Thompson Contender Question

[Freedom95]

Do Octagonal barrels made for the original Thompson Contender fit the later made round barrel fore ends?

 

[Snider shooter]

I assume you mean the G1 contenders. Not exactly the same but will go on. Octagonal barrels have the screw farther out the barrel. Round forearms will go on but they leave a gap between frame and forearm. The sides of forearm will only cover about half of the hinge pin.
Doesn’t look the best but works.

 

[Freedom95]

Thank you for the information. Thompson Center USA did not know the answer to this question.

 

[DANS40X]

OP,
octagon fore ends for octagon Bbls & round inlet for round Bbls.

Thompson Center went under years ago....TC is now owned/manufactured by S&W in MA,USA.