Tightening up an 1892 takedown

[Scrumbag]

Hi folks,

I have been getting my 1892 Chiappa Alaskan sorted out and have put an XS rear peep sight on the rifle:

I have however noticed that the takedown mechanism is a bit loose. It doesn't wobble sideways / up-down but it does rotate slightly with the magazine latched in place:

(Loose at takedown joint).

With the tube rotated a bit further, the lock up is must tighter:

Do you think it is practical to drill 2 more holes in the tube and "re-time" the latch so everything locks up tighter?

(Rather that using the punch method as in the below video)

https://youtu.be/uPEaHAJkVI4?t=839

Advice much appreciated.

Scrummy

 

[BullOnParade]

My chiappa mares leg is very much the same. Probably safest to just leave it as is and accept the tolerance unless you have experience and tools for gunsmithing/machining.

 

[Jake1911]

I bet it would be possible to make a custom tool to thread in there rather than using a punch

The timing isn't something I would worry about

 

[tbough]

I think on the Chiappa you will be able to adjust the fit with the three screws on the takedown extension. No need to hit it with a punch.
At least mine is like that.