Tobin Arms sxs question
- Thread starter lone-wolf
- Start date
I'm still here, just really busy right now. 20 inch barrels were never catologued but I suppose they could have been special ordered. Unlikely though. Barrels shorter than 25 inches were not in fashion back then.
A replacement fore end iron would have to be fitted to the gun. Best bet for parts is to find a broken or beater gun. Having a new one made would be pricey.
Sharptail
A replacement fore end iron would have to be fitted to the gun. Best bet for parts is to find a broken or beater gun. Having a new one made would be pricey.
Sharptail
As sharptail said, I would think it has been cut down.
If you still have chokes in it then could be factory special order.
If cylinder bore, its cut.Have a real good look at the end of the barrels for
square or rough edges.
What does it say on the barrel flats, should give choke spics.
most of these are full and mod, or full/full sometimes
If you still have chokes in it then could be factory special order.
If cylinder bore, its cut.Have a real good look at the end of the barrels for
square or rough edges.
What does it say on the barrel flats, should give choke spics.
most of these are full and mod, or full/full sometimes
There is a sight bead on the end of the gun, if someone cut it down I wouldn't expect them to bother installing a new one. But who knows.
The barrel length might be longer cause when there's no action just all barrel i get fooled sometimes.
The barrel length might be longer cause when there's no action just all barrel i get fooled sometimes.
