Torque wrench

[mildot]

Anyone have a source of some Allen bits (set), that are "quality" and will not "round" on the first use?

 

[RePete]

Anyone have a source of some Allen bits (set), that are "quality" and will not "round" on the first use?

Check with your local Mac tools dealer or Snap On dealer.

 

[BCRider]

Anyone have a source of some Allen bits (set), that are "quality" and will not "round" on the first use?

For gun use you're going to end up needing flat blades as well. So why not just order up a full Wheeler set? The hex tips that come in that set seem to fit pretty well. And fitting well is the first step to avoiding rounding out the screws or ends of the tips.

Having said this I've found that it's impossible to avoid rounding out screws that were over tightened right from the factory. I've seen SOOOO many cases where the OEM makers over torque their fasteners that it's silly.

 

[mildot]

I already have a set of the flat and torx, I just need a the allen bits.

 

[Omkaar]

Hi JR,
The Wiha Torque Driver we sell can accept all standard bits. So if you have a screwdriver set that you got from Home Depot/Canadian Tire/Princess Auto etc. the bits will work with our Torque driver.

Omkaar, does that torque screwdriver that was linked to your site do other than flat and Phillips?

Check out the Chapman Mfg. kits on the site
http://www.gungear.ca/tools/

Anyone have a source of some Allen bits (set), that are "quality" and will not "round" on the first use?