Toz-17 22lr clip

D

dbendall

New member
Rating - 0%
0   0   0
Location
Battleford, Saskatchewan
Hello, new to this site so I hope I am doing this right. I am looking for clip for a TOZ-17 bolt action .22LR it is a 6 round, blued steelbody and floor plate with chromed follower. I have looked far and wide and cannot find a clip for this gun. Below is a link to a website I found and it is the picture at the bottom. Any help would be greatly appreciated.

http://www.ammoclip.com/T/tula_arms_works.htm


Thanks,
Dave
 
An aftermarket magazine manufacter is Krasne's in San Dieago,CA website is triplek.com/product/toz-17-18-22lr-5-rd-magazine You'll probbaly need to import them thru Prophet river tho since I dont know if he ships to Canada
 
Mossberg 802 magazine will fit. There is just a little tab you will have to file off. Most mags are 10 rounds but there are some 15s drifting around.
 
Hopefully Garaldtao is right, they're like hen's teeth otherwise. I lost one of the two factory mags for mine years ago, sold it with one mag.
Superbly accurate little rifles, I'd put them on even terms with CZ and some Anschutz for accuracy.
 
I can confirm a mossberg 802 mag will fit with some minor modification. I filed off the tab on the side and then added small "blob" of jb weld on the back (after slight scuffing) for the mag latch to catch on. I just touched up the blob once dry with a file to fit the half moon on the latch. I haven't seen as many 802 magazines as 702's. I think the only difference is the follower is higher to hold the bolt open after the last round on the semi 702.
To mark the location of the blob I just pushed the magazine into the mag well with the bolt closed and marked it with a pencil.
Good luck.
 
You must log in or register to reply here.
Back
Top Bottom