Tray for 338 LM

[Olisorel20]

Hey guys im looking for a tray to put my 338 LM brass all the one i have are too small
If some1 can give me a rcbs or any other parts number that fit this caliber!!



Thanks have a good one !

 

[jethunter]

Piece of 2x4 and a drill. Seriously better than the plastic loading blocks for big cartridges because it's more stable.

 

[Olisorel20]

That a pretty good idea ! I will do it for sure thanks bud!

 

[Plumsask]

I have also Mde my loading trays from 2x4 using a drill press and a spade bit for my 300 wsm, I'm also a bit on the cheap side.....

 

[iron cat]

I laminated two pieces of 3/4"X12" square plywood together and drilled them for the 338LM cases, nice and stable .
Cat

 

[Olisorel20]

Thanks guy .. seems like i just found a weekend project ��

 

[RePete]

Piece of 2x4 and a drill. Seriously better than the plastic loading blocks for big cartridges because it's more stable.

This is what I did.

 

[257Wby]

I use a 20 gauge Case Gard 100 tray by MTM.
Tray holds 50 and was used in pairs in the case guard box and could be purchased separately at one time.

 

[6MT]

....

 

[jethunter]

I use a 20 gauge Case Gard 100 tray by MTM.
Tray holds 50 and was used in pairs in the case guard box and could be purchased separately at one time.

I had those but haven't seen them for a long time. Wholesale used to sell the trays separately.

 

[iron cat]

I had those but haven't seen them for a long time. Wholesale used to sell the trays separately.

I have a few of them inn 12.
Cat