Vergueiro!!!

F

freire

CGN frequent flyer
Rating - 100%
65   0   0
Location
Eastern Ontario
Gentleman today i bought two firearms, 1 Vergueiro carbine and 1 Vergueiro rifle.
My question to you gentleman with the similar rifle, where did you buy your reloading dies from.
I checked C & H Tool and Die and their web page says no International shipping.
That leaves me with CH4D ?, RCBS?, should i get the Full Length Sizer Die or the Neck Sizer Die , or both?
I know i need a seating die , what about the forming die? can i get away without it or not .
Your advice and ideas will be much appreciated.
Thanks.
Victor.
 
freire said:
Gentleman today i bought two firearms, 1 Vergueiro carbine and 1 Vergueiro rifle.
My question to you gentleman with the similar rifle, where did you buy your reloading dies from.
I checked C & H Tool and Die and their web page says no International shipping.
That leaves me with CH4D ?, RCBS?, should i get the Full Length Sizer Die or the Neck Sizer Die , or both?
I know i need a seating die , what about the forming die? can i get away without it or not .
Your advice and ideas will be much appreciated.
Thanks.
Victor.
Click to expand...

:needPics:

please?
 
I assume you have the guns in the original 6.5x58 Portuguese. I am planning to get the dies as well and CH4D was recommended to me. A 2 die set would work if you have ready made brass, other wise the other dies are used to reform .270 and some other brass. As far as I know converting brass is the only option.
 
I bought my full sizer and seater ch4d dies from buffalo arms and I am going to use a 6.5 Swede collet die from Lee to neck size. Nice rifles, where did you get yours?
 
desporterizer said:
I bought my full sizer and seater ch4d dies from buffalo arms and I am going to use a 6.5 Swede collet die from Lee to neck size. Nice rifles, where did you get yours?
Click to expand...

I posted a WTB ad in the EE over the weekend , my original ad was only for 6.5x58 but this gentleman from Victoria BC had 2 firearms.
1 in 6.5x58 and a converted one in 8x57, and he asked me to take both because he always had them together and didn't want to separate them, now i have 2 8x57 and 1 6.5x58 .
I should be getting them in a week or two.
Your ch4d dies from buffalo arms, were they in stock or did they have to be ordered?
Thanks.
Victor.
 
howard2 said:
I assume you have the guns in the original 6.5x58 Portuguese. I am planning to get the dies as well and CH4D was recommended to me. A 2 die set would work if you have ready made brass, other wise the other dies are used to reform .270 and some other brass. As far as I know converting brass is the only option.
Click to expand...

Can't i form my brass from 270 win or 7x57 using my full lenght 6.5x58 die?
 
tokguy said:
Might be easier and cheaper to go right to ch4d.
I've gotten a few sets of dies from them and they are good to deal with.
Click to expand...

I'll second that motion,like you I have purchased dies and other items direct from CH4D on several occasions.Easy to deal with from any of my experiences.
To the OP,order yourself the 6,5X58 Vergueiro full length two die set and also a file trim die in the same 6.5X58 for forming cases for your rifle from commonly available brass such as 30-06.
 
You must log in or register to reply here.
Back
Top Bottom