I recently bought a 3 and 6 moa vortex venom red dot sight for my benelli m4 or perhaps something else. Does anyone know if there is a mount similar to a sclarworks Rmr mount for a vortex venom that would fit a benelli m4 that would enable cowitness ?
Vortex venom mounting solution for Benelli m4
- Thread starter nick237
- Start date
Auuurrrrrg
Optics and the M4 has always been a bit of a PITA.
When I am running open class I typically just move the stock to its mid point. The more the stock is collapsed in the higher the comb height is.
The only way to get a close "co witness" would be to remove the rail and direct mount the optic to the receiver. OR. get a different stock or modify it to have an adjustable comb height. (The later wont cowitness but at least you can have a proper check weld)
Optics and the M4 has always been a bit of a PITA.
When I am running open class I typically just move the stock to its mid point. The more the stock is collapsed in the higher the comb height is.
The only way to get a close "co witness" would be to remove the rail and direct mount the optic to the receiver. OR. get a different stock or modify it to have an adjustable comb height. (The later wont cowitness but at least you can have a proper check weld)
F22_RaptoR
CGN Ultra frequent flyer
- Location
- Edmonton, Alberta
Getting things to Co-witness with an M4 is so hard with the low sights and the rail height (or even the Scalarworks setup).
My honest suggestion is get a low QR mount like American Defense or LaRue or something so you can take it off if you need to use irons, that's what I have on mine!
My honest suggestion is get a low QR mount like American Defense or LaRue or something so you can take it off if you need to use irons, that's what I have on mine!
canucklehead
CGN Ultra frequent flyer
- Location
- Calgary, AB
Dual illuminated RMR in Scalarworx mount is the ultimate in my opinion. I get lower 1/3 co-witness with the irons.
I tried a T1 in a low mount (Larue 661) but found it still too bulky on top.
Also - get a field stock instead of the collapsible. You can thank me later.
I tried a T1 in a low mount (Larue 661) but found it still too bulky on top.
Also - get a field stock instead of the collapsible. You can thank me later.
Dual illuminated RMR in Scalarworx mount is the ultimate in my opinion. I get lower 1/3 co-witness with the irons.
I tried a T1 in a low mount (Larue 661) but found it still too bulky on top.
Also - get a field stock instead of the collapsible. You can thank me later.
Yesssss. me really want one.....
How is the comb height on it?
Dual illuminated RMR in Scalarworx mount is the ultimate in my opinion. I get lower 1/3 co-witness with the irons.
I tried a T1 in a low mount (Larue 661) but found it still too bulky on top.
Also - get a field stock instead of the collapsible. You can thank me later.
Where do I buy this
