VZ58 short barrels and gas block front sights

[Stevo]

Let's see, Epp's rebarrels Storms to non-res, they could probably do it. Whoever the guy is who rebarrels FS2000s to non-res for Kodiak Outpost could, I'm sure. I know Dlask could.

There's probably plenty more.

 

[lone-wolf]

NEA(Charles Martel) will be rebarreling my czh2003 whenever he gets his barrels made up.

 

[Charles Martel]

Got 50 blanks sitting here (not litterally here as im at home in a really tight pair of boxers on my bed trying to figure out if i feel like bouncing the old lady around, the barrels are sitting on a cart next to the mill turn) ready to go................... Anyways, we are just finalizing a bull barrel with a stainless saddle type gasblock.......... super ###y.

 

[ridgearms]

Let's see, Epp's rebarrels Storms to non-res, they could probably do it. Whoever the guy is who rebarrels FS2000s to non-res for Kodiak Outpost could, I'm sure. I know Dlask could.

There's probably plenty more.

I contacted Dlask about 1.5 years ago about re barreling an 858 and I was dissuaded by the person on the phone saying it was too much work because the gas system has to be fully rearranged. No doubt Dlask could do it if they wanted to though.

 

[mlehtovaara]

Ki11ercane is bringing in some 7.5 inch guns! Not made by CZ but the same design. There is a thread floating around here somewhere.

 

[Charles Martel]

Ki11ercane is bringing in some 7.5 inch guns! Not made by CZ but the same design. There is a thread floating around here somewhere.

They are wolverines guns. Wolverine has exclusive rights to Czech Small arm's VZ's in Canada.

 

[K1ng C]

I was told by a very knowledgeable friend of mine,who is also a member here.That you needed a 10 ton barrel press to install barrels on CZ's properly and there are only a few of these press's in Canada.Yay or nay?

 

[twyeh]

Charles, any updates on when you plan to get this rolling? I also would like to chop down my Vzor. Would it beat the pricing on Wolverines new imports?

Got 50 blanks sitting here (not litterally here as im at home in a really tight pair of boxers on my bed trying to figure out if i feel like bouncing the old lady around, the barrels are sitting on a cart next to the mill turn) ready to go................... Anyways, we are just finalizing a bull barrel with a stainless saddle type gasblock.......... super ###y.

 

[Urban_Ops]

I was told by a very knowledgeable friend of mine,who is also a member here.That you needed a 10 ton barrel press to install barrels on CZ's properly and there are only a few of these press's in Canada.Yay or nay?

Just go to Princess Auto and pick up a shop press. A 12 ton will work but I use a 20 ton that I built.