Warrior lever action shotgun questions: LOP / Extraction

F

Felonius

Regular
Rating - 100%
9   0   0
Hi all,

I am not sure what happened to the thread (it may have been in Corwin's forum) where all the discussion around the lever action warrior shotguns went.

At the time I had mentioned I found that the length of pull was a bit short for me and I could use maybe another inch or more.

Someone had kindly replied mentioning that there were 2 'buttpads' that fit. However I cannot remember what size of each type fit properly, if i recall, one was small the other was medium.

The 2 buttpads were....

Allen slip on and the Pachmayr decelerator. I think the Allen was small, and the decelerator was medium. But I could be wrong.

Does anyone have any insight?



Secondary question, did anyone figure out a way to make the 'ejector' (really just a bit of metal sticking out that the bolt slides past) work a little more effectively? I find even when racking fairly hard, the spent shells just plop out, sometimes I get some hangups because the shell has not ejected properly. I know I can rack it really really hard and it helps, but honestly, racking that hard is a bit of a chore (the small LOP may have to do with it)


Thanks!
F.


additional questions...
does anyone know of a mag tube that fits the 18" version to make it almost flush with the barrel? (ideally flush)
does anyone know what chokes may fit this thread?
 
Last edited:
Mine extracts fine if as above used with authority. Like Daddy taught me with his Savage 99 --- Beat it like it owes you money --- never an issue. I found a leather wrap on the lever is a little more finger friendly in this regard as well
 
Thought I'd update.

I bought the small allen recoil pad from Amazon for 11.99, and it fits almost perfectly, I'd say 98%. It extended the LOP perfectly!


Cheers<
F.
 
You must log in or register to reply here.
Back
Top Bottom