What that means is that both will shoot 1" or less at 100 yards with tuned handloads and a good operator.
I had no trouble getting all my Weatherby Vanguards to shoot 1" and under and they are priced at 500 bucks, so I would have a hard time paying 1700...
Neither of my Mark Vs would consistently shoot 1" or less despite extensive load development,yet almost all of my 700s costing half as much would do better than 1".
For a 257Wby get the vangaurd, get the floorplate done & throw in a Timney trigger, the Vangaurd triggers suck out of the box. You dont need the markV for a 257, it's too much bolt so to speak & too much money, if you were getting a 300, 30-378, 338-378,or a 340Wby & up then the MarkV is a great choice.For a 257Wby it's just status, as far as I'm concerned!!! yah the tube is supposed to be better but save your money, I'm getting .90 to 1.25 groups with factory loads, Via dial caliper!!!! and I'm a shaky bad shot!!! handloads will be tighter obviously.
Vanguards remain the only production rifles to come with a factory-shot target and accuracy guarantee of a 1 ½-inch or better 3-shot group from a cold barrel at 100 yards with premium (non-Weatherby calibers) or Weatherby factory ammunition.
"Weatherby is the only firearm manufacturer to guarantee its rifles' accuracy with a factory-shot target," said Ruddell. "The target is tangible evidence of each Vanguard's accuracy. We take the necessary time to guarantee each rifle's accuracy before the rifles ever leave our doors."
Sako guarantees five shot MOA groups with their rifles.
Not with a factory shot target, however.




























