Saw that, no problem we will hold it until the barrels are ready to ship.
Well, looky what we have here.....
- Thread starter Dlask Arms
- Start date
Saw that, no problem we will hold it until the barrels are ready to ship.
I am having problems field stripping my rifle.
As soon as I got it I took it to the range and fired a few rounds. I did not take it apart first to clean / lube, I figured if it wasn't done during the barrel swap it would at least be fine for a few rounds for me to zero my red dot. I had no problems, the rifle ran great and I was easily able to zero my optic.
Anyways I took it home and started doing the field strip following the steps in the owner's manual but I am running into a problem on step 4 (removing the lower assembly from the rifle). No matter how hard I try I can't get the lower assembly off.
https://youtu.be/VBIwahq4uw0 (you can skip ahead to 2:16 if you don't want to watch me take it apart from the beginning)
According to the manual it is supposed to come back and then you should be able to take it off, however mine does not seem to be able to go back the full distance. When I pull it back, I can see small movements in my trigger, which leads me to believe it is getting caught on something.
As far as I can tell, I am following the steps in the manual to a T. If anyone can tell what I'm doing wrong please let me know.
As soon as I got it I took it to the range and fired a few rounds. I did not take it apart first to clean / lube, I figured if it wasn't done during the barrel swap it would at least be fine for a few rounds for me to zero my red dot. I had no problems, the rifle ran great and I was easily able to zero my optic.
Anyways I took it home and started doing the field strip following the steps in the owner's manual but I am running into a problem on step 4 (removing the lower assembly from the rifle). No matter how hard I try I can't get the lower assembly off.
https://youtu.be/VBIwahq4uw0 (you can skip ahead to 2:16 if you don't want to watch me take it apart from the beginning)
According to the manual it is supposed to come back and then you should be able to take it off, however mine does not seem to be able to go back the full distance. When I pull it back, I can see small movements in my trigger, which leads me to believe it is getting caught on something.
As far as I can tell, I am following the steps in the manual to a T. If anyone can tell what I'm doing wrong please let me know.
Last edited:
It says it comes with 2 mags.
Outcast
CGN Ultra frequent flyer
x2.
I received mine earlier this week and can confirm that they come with two.
For anyone who was following this, I finally got it. Turns out I just had to pull extremely hard. After watching some other disassembly videos, I'm surprised I had to use that much force. I suspect it was because my bolt was very tightly fit inside my gun. I had to use a wooden dowel and a hammer to get it out and put it back in.
Thanks to all of those who offered suggestions!
