were can I find a cartridge lifter for a Winchester 94

[profeser]

Im trying to slick up my Winchester 1894 in 30-30 and buying doing that I wrecked my cartridge lifter , Suggestions on where to buy a new one, Im going to try and fix it, but im not sure if it will be the same ?

Sean

 

[Kevan]

Have you tried Western Gun Parts in Edmonton ?

 

[Flying_Finn]

Numerich out of New York State has always done very well by me.

 

[handofzeus]

Did you lose it or break it? If it's just broken, let me tell you, It's SIMPLE to fix if you can weld! I just repro'd a complete hammer spur to my liking in about an hour and a half including grinding, polishing and oil blackening. Put the broken bit on a piece of brass and start building up the weld. When you have a good solid 'blob' of steel, start shaping with a grinder or dremel. polish, then heat the whole thing to cherry red and quench in a jar of oil. (smokey so be careful). Any flaws, just tack-weld the spot. Good luck.

 

[profeser]

I was trying to slick up the action , It was working but I filed jus a c hair to much, This is my first crack at trying to slicken up the 94, I am proficient in welding so I was thinking about building it up and grind/polish again? Any one every try to slick up you're Winchester 94's

 

[kamlooky]

Any one every try to slick up you're Winchester 94's

I bought a Marlin 336 and liked it so much because of the slickyness, I sold the 94.
Easiest slicknessness I ever done.

 

[Cleftwynd]

I like slickyness too, but isn't that what foreplay is for?

Seriously though, I think I know where several used ones might be found, pm gunrunner100. Great guy, has more rifle parts than Walmart has Chinese made products!

 

[handofzeus]

Try the welding and polishing.

 

[tiriaq]

Which version of '94?

 

[profeser]

Its a pre 64, made in 1953

 

[tiriaq]

Might have one. I'll check.