Ryan500 CGN frequent flyer Rating - 100% 55 0 0 Location Calgary May 12, 2012 #21 Couple questions for the new rig.... Anyone recommend a break in process for this barrel?? Going to run 52g Sierras and varget to start, any advice on seating for these or anything else?
Couple questions for the new rig.... Anyone recommend a break in process for this barrel?? Going to run 52g Sierras and varget to start, any advice on seating for these or anything else?
skypilot CGN Ultra frequent flyer EE Expired Rating - 100% 2 0 0 Location Moronto Bantario May 12, 2012 #23 After sight in and zero, shoot until accuracy degrades or the bullets won't exit the barrel. Then clean sensibly. Use a good rod and guide, dont prang the bore or crown and you'll be fine.
After sight in and zero, shoot until accuracy degrades or the bullets won't exit the barrel. Then clean sensibly. Use a good rod and guide, dont prang the bore or crown and you'll be fine.
Ryan500 CGN frequent flyer Rating - 100% 55 0 0 Location Calgary May 12, 2012 #24 That's about how I break in all my rifles!! Figured I should try something different as this is my only bolt action built before 1945!! And coyote yes, but about 10x more than I was looking to spend!
That's about how I break in all my rifles!! Figured I should try something different as this is my only bolt action built before 1945!! And coyote yes, but about 10x more than I was looking to spend!
