While my Remington 700 XCR RMEF .300WSM was the most accurate rifle I've owned (but took extra work - recoil lugs lapped, UBCed, and Tubbs Final Finish), like the same Remington 700 XCR .300 WSM that preceded it (sans Camo Stock), it could only fit 3 rounds reliably. Also, my first "regular" 700 XCR .300WSM would also inexplicably leave "chatter" marks on bullets when ejected (i.e., unfired rounds that were ejectied from chamber - was sent to Remington and was sent back with problem unresolved). The Sako 85 .300WSM that replaced my second, Remington 700 XCR RMEF has its own issues - I had to order larger optiloc rings and bases (and then a new 50 mm scope - 40 mm scope looked weird sitting so high off barrel) because ejected cases would hit the windage screw covers and fall back into the chamber. Based on my "internet research", I think all the issues I've had with .300 WSM rounds can be traced back to the short, fat design of the cases.
You may be wondering why I have stuck with the .300 WSM - I've invested too much $$$ on Redding Bench seating, sizer dies, WFT trimmer, and other assorted reloading tools to abandon my efforts. If I was to start all over again, I probably would have simply started with 30-06 or 300 win mag (moose is by far, my major quarry).



























