Where can I get 9.3x57 brass?

[otis]

Hey guys. Like the heading says, where can I get 9.3x57 boxer primed brass here in Canada? Thinkin of picking up one of these rifles, but doing some homework first. Give me a PM. Thanks for looking.

 

[burnt_servo]

tradex might have some , if not shouldn't be difficult at all to neck up some 8x57 brass .

 

[Bassmaster]

As mentioned, Tradex......but they've been out for some time
I've formed and used 8x57 from 30.06 brass successfully......I'm not gonna suggest the next move

 

[303EppsFan]

As mentioned, Tradex......but they've been out for some time

Anthony has once fired Norma brass but it's a bit spendy.

 

[Andy]

tradex might have some , if not shouldn't be difficult at all to neck up some 8x57 brass .

It isn't.

 

[antiqueguy]

get some 8x57 mauser and size in a 9x57 die then anneal the neck and load done it a few times

 

[HIGHRPM]

http://www.tradeexcanada.com/produits/87

 

[Northman999]

"Real" 9.3x57 brass is expensive and hard to find.

Most of us anneal 8x57, and then run it through 9.3x57 dies, and you're done.

 

[gunrunner8]

Anthony has once fired Norma brass but it's a bit spendy.

There is no such thing.
Once fired Norma brass will last easily 15 reloads or more than any other brass on the market today.
Spendy? Not in this instance.

 

[tletang]

I usually convert 30-06 using this method.
http://imgur.com/a/WNSvg
The chamber in my rifle was a bit long so converting 8x57 ended up with short case life. with the 30-06 conversion I'm able to push the shoulder back until it just chambers so I can get proper headspace for my rifle. Wish I could find powder to feed it .

 

[303EppsFan]

There is no such thing.
Once fired Norma brass will last easily 15 reloads or more than any other brass on the market today.
Spendy? Not in this instance.

Well I had taken the crowbar to wallet and bought some. My point being others may choose not to.

 

[otis]

Hey guys. Thanks for the good advice.