Where is the Sig SP2022 love?

ArmedGinger

CGN Ultra frequent flyer
Rating - 100%
84   0   2
Location
BC
Even before the handgun ban I never seen too many of these. Personally I believe it's one of the best sidearms I've ever owned out of the hundred or so over the years I've purchased.

Not a whole lot of "aftermarket" support for it although it doesn't really need anything.

Sig Sauer SP 2022.jpg
 
IIRC, did the US Army order some of these for their tank crews?
If this is the pistol I'm thinking of, they were probably the least expensive/reasonably priced SIG out there at the time. Significantly cheaper.

I should've got one when I had the chance, but never seemed availble here after the first lot came in.
 
Last edited:
IIRC, did the US Army order some of these for their tank crews?
If this is the pistol I'm thinking of, they were probably the least expensive/reasonably priced SIG out there at the time. Significantly cheaper.

I should've got one when I had the chance, but never seemed availble here after the first lot came in.

Yes, 5000 were ordered for Armored Vehicle Crews. The largest purchaser of these was France though, over 250,000 were purchased. These are primarily used by Police Officers in various countries.

They were the cheapest Sig Sauer handgun you could buy and one of the most accurate. Everything you wanted out of the P226 for example buy lighter to carry due to the polymer.
 
Had one , shot it a bit and sold it. Seemed like budget polymer 229 option for folks who didn’t want to shell out the bigger money.
 
I don't think there was anything wrong with the SIG Pro models (eg SP2022) but it was always a bit of a stop-gap design that was verging on being outdated by the time it was released.

The SIG P22x (classic) and X-model pistols still have their followers in the shooting sports but largely fell out of favour as a duty-carry pistol. The Sig Pro was theoretically a good option being polymer but became even more short-lived with the quick introduction of modularity from the P250 just a few years later and ultimately a preference towards striker-fired polymers.
 
Back
Top Bottom