I had this idea a while ago that I was going to hand carve a shotgun stock to fit me perfectly. I like woodworking so that's not really my problem. I bought a set of o/u barrels+action from Tradex thinking I'd have everything there and would just need the wood. Everything on it is in very good condition, lockup is tight, it's basically an old Tikka so it will be good for the next 100 years anyways.
The gun in question is a Tikka M17 in the 11K serial range, so early 70's production. Here's a part diagram for the m77 which is essentially the same gun, I found some part diagrams for the m17 that were identical.
M77 parts Diagram: http://www.tikka.fi/sites/default/files/TikkaM77.pdf
M17 parts diagram: http://www.aseinsinoori.fi/Tikka_haulikko_M17.jpg
I need to find the metal bits for the foreend as the gun won't #### the hammers without that piece. I need a 14, I'd also take a 10,11,12,2x13's. A previous owner also removed one of the 6 pins which turns the ejector into an extractor, but I could probably take the one I have to a machinist to make another.
Any idea where I might go about finding these parts?
The gun in question is a Tikka M17 in the 11K serial range, so early 70's production. Here's a part diagram for the m77 which is essentially the same gun, I found some part diagrams for the m17 that were identical.
M77 parts Diagram: http://www.tikka.fi/sites/default/files/TikkaM77.pdf
M17 parts diagram: http://www.aseinsinoori.fi/Tikka_haulikko_M17.jpg
I need to find the metal bits for the foreend as the gun won't #### the hammers without that piece. I need a 14, I'd also take a 10,11,12,2x13's. A previous owner also removed one of the 6 pins which turns the ejector into an extractor, but I could probably take the one I have to a machinist to make another.
Any idea where I might go about finding these parts?
