Where to pin Pmag?

[Scarecrow]

Anybody have the location for the rivet on the magpul Pmags?

 

[beltfed]

I did mine on the spine. Ground down the rivets until flush.

 

[TDC]

I'll post pics and measurements later today(Tuesday).

TDC

 

[simpleton]

How did you get a Pmag mag unless it was already pinned? If you are a dealer, I'd love to buy some Pags from you.

 

[esquif]

i like internal pins like on the m-14 mags that marstar sell. just get a rod and attach that to the base plate

 

[kako911]

Dealers who sell them on this board have them set screwed not riveted.
Its a much nicer way of having them made.

We ran out of them.

Wolverine Supplies will have them in-stock soon.

 

[Scarecrow]

Dealers who sell them on this board have them set screwed not riveted.
Its a much nicer way of having them made.

Ahh like PE90 mags?

 

[Glen Valour]

 

[beltfed]

Pining works as well if not better, and cheaper to do.
Looks just fine as well. Measurement from the topmost, inside bearing surface of the feed lip to the center line of the pin is 2.475" on this mag.

 

[TDC]

As promised, a pic and measurement. I measured from the top edge of the mag body(not the lips) down to centre of rivet. Distance measures 2.070 inches.

TDC