Who sells SS tumbling pins

you can check engine repair shop too.
where i worked we had like 2tons a week of used/burned bearings. some of them, polaris bearings for example, have pin roller inside instead of balls.
 
I just sent John a email about picking some up. I did a search here last night on SS tumbling pins and found "Rooky's " name but the Search Function did'nt Function when I tried to find his name. :rolleyes: I'm building a tumbler and found out that my container is too large, so it's back to the drawing board I guess. Thanks.
9x19p said:
John from Custom Reloading in Maple Ridge, has told me he can supply them.
Would be an easy pick up for you.
Click to expand...
 
iamcanadianeh said:
What's the appeal of SS tumbling pins?
Click to expand...

CleanBrass_zps699e531a.jpg



Cases are left clean inside and out.
No dust.
Media lasts indefinitely
 
iamcanadianeh said:
That's pretty clean.... If the media lasts indefinitely, where does all the gunk go? Or how do you remove the gunk/carbon?
Click to expand...

Its a wet process... Dirt, carbon etc. goes down the drain.

I use a drum I built from 6" PVAC.
Put fins/agitators on the inside.
Built a roller thingy powered by a 1/4 HP motor...
My drum holds up to 800 pcs. of .223 brass.
Add about 15lbs of pins. Fill with water. Squirt of dish soap. Pinch of LemonShine
Cap on... tumble for an hour or two.

[Youtube]YmTjfo4H4cA[/youtube]
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom