WINCHESTER 1300 DEFENDER...how do you dissasemble?

S

surreysinner

Member
EE Expired
Rating - 0%
0   0   0
Location
bc canada
May sound stupid to some but i cant figure it out.

I got the barrel off, popped the the pin on the back and am lost after that.

This thing is dirty and needs to be cleaned. Anyone have some insight for a newb? Pics or a Vid?
 
After bbl is removed, remove rear (only one) takedown pin, next grasp trigger mech by the trigger guard and pull down & toward forestock/bbl.
Now that trigger mech is removed, slide forestock/action fully to the rear, next push the spring steel ejector rod(its the flat piece that rides along left side of interior of reciever) towards wall of reciever so as to flatten, this will allow the bolt to slide forward and off action bars, the forestock and action bars will slide forward fully until clear of reciever, the bolt will be free and can be removed , the ejector can be pushed against its spring toward the butt and lifted off its tab. Any further disassembly should'nt be required unless you plan on changing butt & forestock. Good Luck,
 
Ok got it torn down and back together. The pistol grip was stoppin me from pulling the trigger assembley and i didnt notice.

Thanks guys your replies helped me out a lot.
 
You must log in or register to reply here.
Back
Top Bottom