I obtained this 1894 20 inch Carbine in a recent transaction.
Hopefully I did not pay to much for it....
This is what I have found out about this particular rifle:
It has a "Modified shotgun style buttplate"
It has the twin Pre-64 single elevator screws. (Left and right side of the receiver)
It features an extended walnut fore end (Serials numbers 1,900,000 onward were the shorter version)
The "Tang" sight is a Lyman Combination sight marked "DA". I think it is a pre-1905 sight.
The barrel sight is a longer series 44 "Adjustable leaf rifle sight" (1916 on) graduated out to 2000 yards.
The post-64 Winchester model 94's begin with serial number 2,700,000.
The Winchester Book - George Madis 1977
Page 594 "Short rifles which were made on special order have barrels of rifle weight and seldom have saddle rings; while saddle rings would be fitted if ordered, the majority of short rifles were not thus provided."
Page 596
"Nickel steel barrels were proofed with loads from 25 to 50% greater then normal loads. The barrel was carefully inspected for signs of any possible weakness. If there was any sign of strain on the barrel, it was condemned"
Hopefully I did not pay to much for it....
This is what I have found out about this particular rifle:
It has a "Modified shotgun style buttplate"
It has the twin Pre-64 single elevator screws. (Left and right side of the receiver)
It features an extended walnut fore end (Serials numbers 1,900,000 onward were the shorter version)
The "Tang" sight is a Lyman Combination sight marked "DA". I think it is a pre-1905 sight.
The barrel sight is a longer series 44 "Adjustable leaf rifle sight" (1916 on) graduated out to 2000 yards.
The post-64 Winchester model 94's begin with serial number 2,700,000.
The Winchester Book - George Madis 1977
Page 594 "Short rifles which were made on special order have barrels of rifle weight and seldom have saddle rings; while saddle rings would be fitted if ordered, the majority of short rifles were not thus provided."
Page 596
"Nickel steel barrels were proofed with loads from 25 to 50% greater then normal loads. The barrel was carefully inspected for signs of any possible weakness. If there was any sign of strain on the barrel, it was condemned"
Last edited:




















































