So I have two bags new Winchester brass 7MM Rem mag of which I was trying to run through the resizing die as there were many with deformed case mouths. The problem is so far almost all of the cases are very difficult to get into the shell holder.
I checked to see if it is the correct shell holder, it is #4 so I tried another shell holder #4, same problem, then I tried some out of the second bag,thinking it was a batch problem, same problem ( could be same batch).
I have never had problems with Winchester brass before and never have used anything different.
Has anyone had similar problems or words of advise.
At $50.00 a bag it is a problem and I do not want to go through this every time I resize.
I checked to see if it is the correct shell holder, it is #4 so I tried another shell holder #4, same problem, then I tried some out of the second bag,thinking it was a batch problem, same problem ( could be same batch).
I have never had problems with Winchester brass before and never have used anything different.
Has anyone had similar problems or words of advise.
At $50.00 a bag it is a problem and I do not want to go through this every time I resize.
