Winchester tang sight spacing ???

[Brutus]

Does anyone know the Winchester M94 or M92 tang sight spacing for the mounting holes on the upper tang of these older rifles or carbines ??
Can I assume Marbles and Lyman are Winchester friendly? Meaning no drilling extra holes ??

Curious

 

[remp49]

2.185 inches center to center.

 

[450yukon]

2 3/16 inches C to C for both.

 

[Brutus]

Thanks very much folks.

 

[Brutus]

2.185 inches center to center.

I just checked screw hole spacing my 1901 shotgun tang
Right at 1.85 inches.
Interesting.

 

[450yukon]

Tang sight on a shotgun? I never thought of that.

 

[Brutus]

Just an experiment for slugs. Something I could mount or remove at will.
Maybe

 

[sean69]

Does anyone know the Winchester M94 or M92 tang sight spacing for the mounting holes on the upper tang of these older rifles or carbines ??
Can I assume Marbles and Lyman are Winchester friendly? Meaning no drilling extra holes ??

Curious

sounds like everyone has the spacing down right ... though if you want to be sure ~ call the manufacturer ~

also, if holes need to be drilled - drill them in the sight base, not the receiver. if holes are slightly out (even by 0.250") or so, you can drill and file one of them into an oval slot.