WIP....but its a gun!!
- Thread starter Klunk
- Start date
I looked at lots of photos of lots of 30mm-75mm anti tank guns and then built one in my garage with junk I had laying around...
....Except for the DOM barrel-dodge minivan axle-some steel-Carl G scope-Iltis wheels-nuts bolts bearings....etc etc etc...
Try it sometime!
couple shots of the working side of the shield....gun traverses left and right about 45 degrees and elevates/depresses about 35 degrees
trailing arms open up/spread out like they should
Optics are bore sighted to gun
barrel is full recoiling using a motorcycle fork for a recuperator (adjustable and air chargeable)
barrel is at machine shop right now-when complete it will be percussion fired-breach loaded BP with a bore of 29mm- or 1 1/8"
MauserMike
CGN Ultra frequent flyer
- Location
- SW Ontario
some people have the coolest toys 
great work!
great work!
- Location
- West Quebec
not a dam clue...got a chrony you would put in front of it?
You should be all right with a Chrony in front of it. Last July we fired several rounds from a Hotchkiss 25mm AT Gun over a Chrony.
.
.
This photo is a bit "fuzzy" as it was taken from a movie clip. The movie shows only ONE frame with the muzzle blast and tracer from the original factory round.
.
Last edited:
that's the little AT gun that kick started my build of the one you see here
If you have a movie POST IT UP!!
