XCR Gas Setting Question????

[Liquid_Snake]

I am not sure what it should be set as for more eject. I am useing light 762 loads and just plinking a gong and I need more eject. Right now its set at #2 on the gas block

 

[starblanket]

Try #4.

 

[j_san]

hmmm, try the next two settings that have a smaller hole in the gas port #3 or 4. The S1 position is apparently for suppressors and rifle break-in. then again, my XCR is in .223
I made a few "light loads" but you must manually eject them...that was my original intention to go subsonic though.
best of luck!

 

[Liquid_Snake]

Was just not sure what way it went I will try 4

Thank you very much

 

[hbean]

adjust your dial until the shell ejects out to about 9'-12', higher the number mean more gas is being directed to the piston.

 

[Jäger1]

Setting 4 might lead to a destroyed recoil buffer after some time.

S - for use with a silencer
1 -
2 -
3 -
4 - For the break-in period...shouldn't be needed after the first 2-300 rounds.

S allows the least gas to impinge on the piston, 4 allows the most. Settings 1-3 should work for most factory loads...use the lowest possible setting where the rifle still cycles.

To answer your question specifically....bump it up to 3 before you try 4...

 

[BeerBaron]

I agree... Try 3 and see if it works there before going to 4.