XCR-L trigger group problems - help wanted

M

msarazin

CGN Regular
Rating - 100%
72   0   1
Location
Winnipeg
I was happily shooting 7.62 x 39's for a few hours and making great progress at sighting in the rifle, when I realized that the hammer pin had creeped out of the lower receiver about half the pin length.

So I stopped shooting and field stripped the lower to find that a small cotter pin and was lying inside of the receiver.

A few questions, 1. anyone else experience this? 2. anyone have a drawing or picture so I might properly put the hammer assembly back together?

I have everything back together, just want to make sure it's correct. The trigger, safety and hammer seems to function properly.

Thanks for the help!
 
Last edited:
Shoot me a pm with your e-mail address. I'll send you a PDF of the XCR-L Armorer's Course Manual.
 
Just make sure the hammer spring is resting on top of the trigger pin and once you seat that cotter pin in place just bend the ends, so they don't slip out again.
 
You must log in or register to reply here.
Back
Top Bottom