XCR-M Operator's / Owner's Manual

[Xero]

Hey everyone, I was able to get a direct PDF copy of the Owner's / Operator's Manual for the XCR-M directly from Robinson Armament. I wasn't able to find a public link to download this anywhere when looking for it, so I figured I'd throw it on Dropbox for everyone to benefit from.

Before you read though, please be aware of the corrections posted by Grumpy Wolverine directly below this post (thanks Grumpy).
XCR-M Manual 31Jan12.pdf

Hope this helps some folks out. Enjoy!

 

[Grumpy Wolverine]

That manual has some improper information in it. It says to break your rifle in on gas setting number 4. Please do not do this. Turn your gas setting down to the lowest setting it will function properly on and break it in there. Then after a few hundred rounds see if you can set it down even lower.
Also the torque spec for the barrel bolt is 250 inch pounds, not 200.

 

[Xero]

Alright, I updated the first post a bit. If you find any other inconsistencies with the manual perhaps you can update you post listing them?

Cheers,
Xero

 

[Grumpy Wolverine]

Sure will do, but I think those are the two biggest ones. The rest of it is to remember to run these guns very very very well lubricated.

 

[Xero]

This is, of course, a joke.

How to lubricate an XCR-M:
1. Lock bolt to the rear position.
2. Expel entire bottle of frog lube into action.
3. Cycle action until smooth.

That about right?

 

[tavares86]

This is, of course, a joke.

How to lubricate an XCR-M:
1. Lock bolt to the rear position.
2. Expel entire bottle of frog lube into action.
3. Cycle action until smooth.

That about right?

Haha

 

[Grumpy Wolverine]

This is, of course, a joke.

How to lubricate an XCR-M:
1. Lock bolt to the rear position.
2. Expel entire bottle of frog lube into action.
3. Cycle action until smooth.

That about right?

Actually you couldn't go wrong with that method. More lube is better than less lube.