Zoom ring on Nikon Monarch 3 scopes

P

pacobillie

CGN frequent flyer
Super GunNutz
Rating - 99.3%
149   1   0
Location
Quebec
I own two of those scopes, a 2.5-10X50, and a 2-8X32. Both have great optical quality, but share the same two flaws:

1- The length of the tube to mount the scope is short and best suited to a short action rifle. Offset rings are required for long action rifles.

and

2. The zoom ring is slippery. It offers very little grip and is difficult to turn with gloves on. Does anyone know of a solution to obviate the latter?
 
Mind you sharing what is the OD size on your Nikon zoom ring/parallax ring?
I am looking for a "throw lever" for my Falcon scope.
There are plenty of these on amazon and everywhere on world web for a fraction of the cost, but no dimensions only a generic description "this one is for Nikon, or Leupold or like that". I have seen low as $15 for the ID 44-48 mm.
The hole ID I am looking for in throw lever is 38mm = 1.5"
 
bigHUN said:
Mind you sharing what is the OD size on your Nikon zoom ring/parallax ring?
I am looking for a "throw lever" for my Falcon scope.
There are plenty of these on amazon and everywhere on world web for a fraction of the cost, but no dimensions only a generic description "this one is for Nikon, or Leupold or like that". I have seen low as $15 for the ID 44-48 mm.
The hole ID I am looking for in throw lever is 38mm = 1.5"
Click to expand...


Nikon Monarch 3 has 41.25 mm OD zoom ring
 
You must log in or register to reply here.
Back
Top Bottom