G9 Mag Adaptor, Pics and Installation thread

Mine is on the way. Once it arrives it goes straight to my gunsmith. I know my limitations. I have a tapco stock on my SKS which will need to be modified which should not be a problem for him. I'll post the finished project in a couple of weeks. Looks like a winner to me. I would have preferred a conversion kit for a CZ 858 to make the cost a bit closer to the price of a rifle but it is what it is, Either the SKS is under priced ot the CZ is over priced.

Take Care

Bob
 
sametwinnie said:
Do you think it's possible to do the modification with a drill press and a small milling table?
Click to expand...

Yes. Obviously better tools will be faster and cleaner but a drill press with a milling table isn't bad.
I do believe you need to consider carefully what bit to use in the drill press so l will see if I can get some decent advice on that for you.
 
sametwinnie said:
I really want to know this because I want to run on stripper clip and 10 rds pistol mag... I purchase the kit to do so!!
Click to expand...

I think I answered this before.

I have never used a stripper clip in an AR style mag so am unfamiliar with this notion ... I think the whole point of this conversion is to have a detachable mag which can legally hold 10 rounds.
 
Looking forward to this!
Fresh russian sks to use as a donor.
I'll be using my milling machine for this project.
Dave, as per my p.m. , I'll be in touch after my moose trip ;)
 
Well mine was in Richmond yesterday. It should arrive tomorrow. With luck I should be testing it out by the middle of next week if my 'smith can do his magic for me by then. I am putting it on an almost virgin Russian with a Tapco stock.

Take Care

Bob
 
Mine arrived to day. Thanks Dave. I took it to my 'smith to install. It may be awhile before he gets to it. I am not skilled enough to attempt it myself. I'll post pictures when it arrives all done.
Bob
 
You must log in or register to reply here.
Back
Top Bottom