Type 81 Owners Corner !

Cranswick,


JosEXLb.jpg
[/url][/IMG]

Man it's hard to find a non ghey thumbs up.
 
Last edited:
Gun123 said:
The trick is pushing the button with either the tip of a bullet or a pen. Once you get the hang of it, it goes on smoothly.
Click to expand...

I've found that you don't need any tools or a bullet tip, you don't actually have to push the button in past flush, just push it in and gently pull up and back and it will clear the little lip on the back of the receiver.
If the button doesn't pop back out on reassembly either cycling the action or slightly rocking the dust cover side to side will make it pop out.

cranswick said:
my buddy is filming, that's me throwing my mags in the dirt, cause i'm hard as ####, lol...
Click to expand...

Lol, just remember that there may not be any more mags available for a while. These seem quite robust so I doubt dropping them in the dirt would do any harm and even though you can easily modify an AK pmag to work I like the bolt hold open feature so the pmags aren't the greatest option.

If needed this is what you need to do to a pmag to get it to work. Took me about 15 min of messing around but now that I know where it needs to be fitted I can probably do it in a couple minutes
AK Pmag mod.jpg
 

Attachments

  • AK Pmag mod.jpg
    AK Pmag mod.jpg
    83.9 KB · Views: 236
Last edited:
winchester94 said:
The 2 pcs on the top were separate from the 4 pc kit.(fixed stock)
View attachment 132483
Jag, brush, extension and a punch. The other 2 are a gas port cleaning tool? And a front sight elevation adjustment tool.
Click to expand...

Other two are, Cleaning rod T-handle and front sight elevation tool.

The T handle goes through the hole on the cleaning rod and locks it into the cleaning kit housing. Also used with the sight tool as a handle.
 
Dsiwy said:
Other two are, Cleaning rod T-handle and front sight elevation tool.

The T handle goes through the hole on the cleaning rod and locks it into the cleaning kit housing. Also used with the sight tool as a handle.
Click to expand...

Its a gas port cleaning tool, not a T-handle for the rod, doesnt fit in the rod hole. The small puch is used to lock the cleaning kit housing to the cleaning rod.
 
cranswick said:
what I is put the bottom of the dust cover over the button, and just push it on till it's seated in front of the steel ledge ahead of the butt stock and wiggle it till the button pops out...it's very easy once you get used to it...

here's a short video my buddy took...

Click to expand...

Yeah! There you go!
Beat that f**cking thing!
She is looking promising indeed :rockOn:
 
You must log in or register to reply here.
Back
Top Bottom