- Location
- West Quebec
Have you considered Bullseye?
As long as you are not competing with it W231/HP38 is a very good powder for 9mm.
231 will burn clean if shot at full pressure. If you make a mild load with it, it does not burn as cleanly.
Try N320. You will like it.
Dillon 650
231 will burn clean if shot at full pressure. If you make a mild load with it, it does not burn as cleanly.
Try N320. You will like it.
You need to set up your shellplate so it drags just a bit, that way you shouldn't get any powder spillage.
Anyone know if Vihtavuori is available in the Okanagan area?
Sorry for being simple but could you not just be easier on the handle..? I too have a 650 and after a 5000 round run I doubt there is more than a few loads worth of powder spilled. Titegroup is hard to beat since it can be bought for less than nearly anything else similar. It meters well and produces adequate velocity for most uses.
Del Selin in Vernon does not carry it. Not sure about Vernon Cambodian Tire, you'd have to talk to Brandon or Matt there. They have a surprisingly large reloading section.
Henry @ Budget Shooter Supply in Surrey does sell it, no Hazmat fee. Awesome vendor to deal with.
https://www.budgetshootersupply.ca/...omponents/smokeless-powder/vihtavuori-powder/
Henry is going to SHOT so won't be shipping until he gets back.
Tends has it for a little under $50 per lbThanks for the link.
N320 is pricey - from my quick math it comes in around double the price of Titegroup.
Tends has it for a little under $50 per lb
Tends has it for a little under $50 per lb




























