Sterling Arms TR

Status
Not open for further replies.
The 2 issues we've seen:

1) The front pivot pin retaining spring needs to be trimmed about 1/3 of an inch as the hole is not deep enough in the original design. Not a biggy.

2) The bolt catch retaining screw cannot be tightened all the way or it binds the bolt catch. Adjust it out till the bolt catch moves freely and leave it. It won't back out.

JR

Sorry I have not put mine together but I have the DPMS LPK and it says nothing about a bolt catch retaining screw (maybe its there i just not sure). Do I have to purchase separately?
 
The bolt catch retaining screw comes with the receiver set. I used a DPMS LPK and other than trimming the front takedown spring as mentioned, had no issues during assembly.
 
Mine is together and functioning but will not hold open with magpul magazines. Is this normal - steel mags works fine. And I did keep the bolt catch screw loosend back a few turns as suggested above.

Edit - I backed it out alot more and now it seems to be working better, should I put on loktite as it seems like it may back out.
 
Last edited:
I just want to comment on the reciever set. Everything was interchangeable. However, the dust cover need the round rod that uses the c clip (The C clip wouldnt be needed).

Only problem i have is the bolt catch. It works with an empty mag. But if I do this manually, i would need to pull all the way back, very very hard.
 
We are selling off the "cancelled" ones. Still a couple left.

Call the shop: 403-720-4867 and ask for Logan.

JR

JR

Mine came with a rusty somewhat unfinished (like a raw light grey not black) rear take down "pin", possible to get a replacement?
 
Tried calling the shop to buy a couple of uppers, but the guy who answered seemed to have no idea what I was asking about. Emailed and PMd as well, so fingers crossed

EDIT - Thanks for the response, JR. Looking forward to my two uppers once Logan gets back!
 
Last edited:
Okay:

1) We are not going back and forth with "what serial numbers are available?"...

2) We are not discounting these.... any emails "insisting" on (yup... "insisting" ) a discount are to be moved to the bottom of the list.

Thanks for your continued support.

JR
 
Okay:

1) We are not going back and forth with "what serial numbers are available?"...

2) We are not discounting these.... any emails "insisting" on (yup... "insisting" ) a discount are to be moved to the bottom of the list.

Thanks for your continued support.

JR

Wow, some people. White glove, silver platter requests when the similar alternative is to wait a year...
 
I sent my email august 10th, to be put on the list.. still Waiting a email, or a call...


Please send me another email. If I have not gotten back to you, you may have been lost in the junk folder. please send an email with your CGN username to websales@theshootingedge.com and I will look after you.

Thank you.
 
Status
Not open for further replies.
Back
Top Bottom