CZ Bren 2 MS NON-Restricted MAJOR UPDATE Post 587

Danol said:
Has anyone noticed the threaded hole under the bottom handguard at the far back missing a screw?
I’ve seen a picture on Reddit and it seems that other people have a threaded hole without any screw in it.
Maybe Dlask can chime in on what it’s for?
Click to expand...

I see it now that you mention it. It has a "M" next to it.
 
Thanks.... I should have mentioned that I was looking at Marstar's offering, which the conversion was based off the 11in barrel. I'll pass for now, as the rifle looks hideous even with the thee 13.8 in the handguard.
 
Danol said:
Has anyone noticed the threaded hole under the bottom handguard at the far back missing a screw?
I’ve seen a picture on Reddit and it seems that other people have a threaded hole without any screw in it.
Maybe Dlask can chime in on what it’s for?
Click to expand...

Attachment point for factory CZ handguard. The HBI unit the U.S. made guns come with do not use those holes.
 
Has anyone gone the route of converting their 11in bren 2 to 18.6 in barrel nr status and attaching a 13.8in handguard? I was just curious on how it looks. And don't want to scroll though 100+ pages.
 
ganger631 said:
Thanks.... I should have mentioned that I was looking at Marstar's offering, which the conversion was based off the 11in barrel. I'll pass for now, as the rifle looks hideous even with the thee 13.8 in the handguard.
Click to expand...

I agree with you that it looks bad with the 13.8” Handguard. Leaving that much barrel exposed also creates the potential for damaging it, as well as shifting POI from inadvertently resting the barrel on an object when shooting off barricades, rests, etc.

I’ve got an 11” converted to NR on the way, and I’m going to put the 15.8” Handguard on. It’s aesthetically the best looking configuration for the NR Bren 2s. I’ll just have to modify it a bit so I can access the gas regulator for adjustment. Seems like the best solution if running them NR.
 
1955FL said:
I agree with you that it looks bad with the 13.8” Handguard. Leaving that much barrel exposed also creates the potential for damaging it, as well as shifting POI from inadvertently resting the barrel on an object when shooting off barricades, rests, etc.

I’ve got an 11” converted to NR on the way, and I’m going to put the 15.8” Handguard on. It’s aesthetically the best looking configuration for the NR Bren 2s. I’ll just have to modify it a bit so I can access the gas regulator for adjustment. Seems like the best solution if running them NR.
Click to expand...


Just verifying this is the handguard you are saying is too short?

2FB6WJ8.png
 
You must log in or register to reply here.
Back
Top Bottom