^ ^ ^ ^ ^
Rim thickness measurements with match grade ammunition resulted in creating two lots that would best be described as high and low readings.
No appreciable differences were detected from the two lots nor out of the box.
Measuring rim thickness after firing from my Remington did not disclose any changes. The measurements before and after were the same.
The test was based on Eley Match shot from an Eley Match Chamber.
Weighing the rounds has four main variables . . . case, powder, lubricant and the bullet.
When there appeared to be excessive amounts of lubricant on some match ammo, it was wiped off. That was not the answer.
Pulling bullets to check for consistency is not the answer either.
Altitude density was the solution in an article but that is too complicated. Not many would go to a match with four lots of ammo and changing with the readings as the match progressed. NOT I!!!
Match ammo is part of the solution but testing must also be added to the equation.
That testing is not based on one five shot group. My standard is five 10-shot groups within a range of velocities that have proven consistent in the past.
During one test of five different lots, one lot was scrubbed after three groups and another after four. One lot had one group over an inch at 100 yards and over time two cases of that lot were acquired.
This can be cost prohibitive to many so luck of the draw might be the answer to many.
At a shoot in the past, the leader on the first day fell off the board on day two. His response was SSDD . . . Same shooter different day.
Rim thickness measurements with match grade ammunition resulted in creating two lots that would best be described as high and low readings.
No appreciable differences were detected from the two lots nor out of the box.
Measuring rim thickness after firing from my Remington did not disclose any changes. The measurements before and after were the same.
The test was based on Eley Match shot from an Eley Match Chamber.
Weighing the rounds has four main variables . . . case, powder, lubricant and the bullet.
When there appeared to be excessive amounts of lubricant on some match ammo, it was wiped off. That was not the answer.
Pulling bullets to check for consistency is not the answer either.
Altitude density was the solution in an article but that is too complicated. Not many would go to a match with four lots of ammo and changing with the readings as the match progressed. NOT I!!!
Match ammo is part of the solution but testing must also be added to the equation.
That testing is not based on one five shot group. My standard is five 10-shot groups within a range of velocities that have proven consistent in the past.
During one test of five different lots, one lot was scrubbed after three groups and another after four. One lot had one group over an inch at 100 yards and over time two cases of that lot were acquired.
This can be cost prohibitive to many so luck of the draw might be the answer to many.
At a shoot in the past, the leader on the first day fell off the board on day two. His response was SSDD . . . Same shooter different day.
Last edited: