Question about the bolt roller greaser, is the tool suppose to fit over the roller bearing? The two I have from brownells do not. I would think you fill them with grease and as the tool goes over the bearing it forces grease through the bearing.I have been meaning to take a fine strip of sandpaper in a tool on my drill and polish the interior till it just slides over the roller,just wondering if this is the way it is suppose to be?
greaser for the bolt roller
- Thread starter wce323078
- Start date
A few drops of G96 oil or Mobile 1 in the roller and grease on the outside works very well. Just a friendly FYI. G96 oil on the Op Rod guide and Op Rod tube is very nice.
Everything else...grease + a smidge of G96 on top.
Slicker than a banana peel
I have the badger ordnance greaser and while it's a snug fit, it works very well, purging the old grease and replacing with new.
My other greaser that is more of a relic now, but works equally well is a .308 case, cut behind the neck, filled with wax, with enough space for the roller to sink in. Drill crossways through the end and insert a section of drill rod for a T handle.
My other greaser that is more of a relic now, but works equally well is a .308 case, cut behind the neck, filled with wax, with enough space for the roller to sink in. Drill crossways through the end and insert a section of drill rod for a T handle.
