So I fixed up an old cooey, nothing too too crazy but certainly far from what it was. as of right now im looking to mount a scope. I have two weaver part numbers but am finding mixed reviews on which I need and what exactly the best way to go about it is. It does have the holes drilled for the side mount. but has no grooves in the receiver. Being that at I have other financial priorities I'd like to lean towards the cheaper end of the scale, that said if I can get something decent for a reasonable price; probably check the EE later when I have more time, I'll do that. Essentially what is most cost effective but not necc just the cheapest option (for the scope that is, the mount I'd like to know where to find it the cheapest, or even used!)
so cliffs-
-cooey 600 running rabbit with factory drill/tap for scope but no grooves in the receiver
-looking for suggestions on a scope, decent but not crazy expensive or total garbage
-also need to know what mounts Ill need, from the info I have it looks like I can get either weaver #48402 OR weaver #49350 but I seem to find ppl saying I need both, as well as ppl saying neither of these numbers are applicable.
so cliffs-
-cooey 600 running rabbit with factory drill/tap for scope but no grooves in the receiver
-looking for suggestions on a scope, decent but not crazy expensive or total garbage
-also need to know what mounts Ill need, from the info I have it looks like I can get either weaver #48402 OR weaver #49350 but I seem to find ppl saying I need both, as well as ppl saying neither of these numbers are applicable.



















































