Fake Cans and barrle shrouds
- Thread starter badboybeeson
- Start date
Cone_Skid_Cone
Regular
- Location
- Grande Prairie
I'd like to strip the finish and annodize it. Vent holes may be added eventually. It's a bit tricky to figure out how to completely strip the flashlight, but there is a lot of useable threaded bits in there. I cut it down about 2", and swapped to a grinding disk to make the muzzle end flush with the shaft diameter. The drills were mostly used as a temporary lathe. As I cut down the flashlight, I lost the threads on one side. That end was just pressed on, using the threads to bind it in place. I used teflon tape on the VZ's threads to help keep the shroud flush with the end of the barrel. The factory thread protector is what I used as the actual mounting point.
(Seekins precision style)
That would make it a suppressor...and illegal.
Barrel shrouds come back over the barrel leaving the muzzle exposed as normal.
They only give the appearance of a suppressor with no actual decrease in sound.
Last edited by a moderator:
- Location
- East ontario
ok ladies I,m going to delete a bunch of these post, to save you all a visit from the RCMP.
bbb
bbb
buzzmagoo
CGN Ultra frequent flyer
- Location
- sprucewood Hallows Eastern Townships
You opened a big old can of worms here EH! Happily you have decided to Dive Right In ! Gladly there are still movers and shakers hear in the Canadian firearms industry. Thanks for keeping your ear to the gun comunity ( sometimes the mob LOL!) Wants and needs. Hold steady, and stay the course! Tip of hat!
- Location
- East ontario
You opened a big old can of worms here EH! Happily you have decided to Dive Right In ! Gladly there are still movers and shakers hear in the Canadian firearms industry. Thanks for keeping your ear to the gun comunity ( sometimes the mob LOL!) Wants and needs. Hold steady, and stay the course! Tip of hat!
We want to do this. It's on the list for sure but we have other long term projects that we were working on before this.
Like getting some of our ar15 parts back on the market lpk gas blocks buffer tubes ambixsafetys xand barrles
But again we are working on it
