- Location
- Alnwick Haldimand
10/22 photos - post 'em up here!
- Thread starter mchaley
- Start date
adding a couple more to post #8.....
Where did you get the mag on the third rifle? Do you know if you can still buy them?
It's a ProMag without the AR shell
- Location
- Alnwick Haldimand
Oooops...
It's an M1 steel mag gutted and epoxied to a OEM 10 round 10/22 mag
Thanks
My fav shot of mine.
11.5" ER Shaw
Leupold FX-II 2.5X20mm w/ prw low rings and PC base.
VQ bolt handle & extractor, buffer and hex take down installed. Trigger assembly polished. Receiver stripped and sanded. Butler creek target stock, sanded down.
Shoots and carries like a dream.
11.5" ER Shaw
Leupold FX-II 2.5X20mm w/ prw low rings and PC base.
VQ bolt handle & extractor, buffer and hex take down installed. Trigger assembly polished. Receiver stripped and sanded. Butler creek target stock, sanded down.
Shoots and carries like a dream.
Very classy
Heres my Tapco Blaster
Here is my 10/22 for your consideration. It has been an ongoing creation over 5 years. At this point I am done with this one except for paint. Not a lot into it really as everything was bought used except for the stock and barrel. The most that was spent was time but it was a lot of fun.
Dlask 12.5" barrel with thread protector
Volquarsten, sear, hammer, and extractor
Tapco T6 heavy barrel stock with extra rail cover on handguard, straigth tube is epoxied permanent.
BSA 4x compact scope
weaver see through rings for height
DIY trigger overtravel stop
DIY bolt release
Coffin case made for guitar hero
Its as light as a factory sporter set up, balances nicely, and groups inside a 1/2" at 50 yards using winchester wildcats.
I really like how tapco combines the pistol grip and adjustable stock while keeping the forend fairly conventional, its really ergonomic.
Thinking of painting the stock beige, any other ideas on colour?
Here is the wifes, trigger polished, shortened butt painted with....yes lady bugs.
Here is my 10/22 for your consideration. It has been an ongoing creation over 5 years. At this point I am done with this one except for paint. Not a lot into it really as everything was bought used except for the stock and barrel. The most that was spent was time but it was a lot of fun.
Dlask 12.5" barrel with thread protector
Volquarsten, sear, hammer, and extractor
Tapco T6 heavy barrel stock with extra rail cover on handguard, straigth tube is epoxied permanent.
BSA 4x compact scope
weaver see through rings for height
DIY trigger overtravel stop
DIY bolt release
Coffin case made for guitar hero
Its as light as a factory sporter set up, balances nicely, and groups inside a 1/2" at 50 yards using winchester wildcats.
I really like how tapco combines the pistol grip and adjustable stock while keeping the forend fairly conventional, its really ergonomic.
Thinking of painting the stock beige, any other ideas on colour?
Here is the wifes, trigger polished, shortened butt painted with....yes lady bugs.
Last edited:
Nick_Burns
New member
Here's mine. I have it set up a bit different now though.
what kind of kit is this? looks very nice.
In long
I want a marauder stock but havent seen any with the adjustable stock, where did you get that!
