30-06 loads....list them!

hawk-i

CGN Ultra frequent flyer
Rating - 100%
9   0   0
I tried searching for a thread on this subject but nothing came up.

What are your favorite loads for your 30-06, hunting, target,or reduced, please list them!
 
Retired my 30.06 but used it only for hunting.

60.5 grains of H4831 under 180 grain Swift A-Frame - large rifle primer - whatever brass I had for it (not picky myself) - my old moose round.
 
180 Partition or Accubond, 62 grains of Norma MRP

165 Partition or Accubond, 60 grains of W760 [SL10]

150 GMX, 60 grains of RL 17.

Do NOT use any of these loads without starting at least 2 grains lower!! Dave.
 
M1 Garand 46.0 4064 165 gr Hornady SP
Browning BAR 47.5 4064 165 gr Hornady SP
03A3 21.0 2400 180 gr 311291 sized 311
03A3 25.0 H4198 180gr 311291 sized 311

As always check all "internet" loads in a reliable source before using
 
56 grs IMR 4350 with a 180 Nosler partition, gives 2750 fps.
Bump that up one grain for 180 Rem core lokt
59 grs IMR 4350 for conventional cup/core 165 gr., runs about 2900.
 
56GR IMR 4007SSC Lapua brass, Rem 9 1/2 primer, 165gr Swift Scirocco ll. 2960FPS for 5 shot average from a 22" tube.(Bullwinkle)
56GR IMR 4007SSC Lapua Brass,Rem 9 1/2 Primer , 165gr Sierra Game King HPBT 2890 FPS 5 shot Average from a 22" tube.(Bambi)
Same POI at 100 yards.. have not tested out to 200 or 300 yet but should be close.. all average 3/4" groups per 5 shots... which i find is great accuracy for MO DEER/ MOOSE :D

Regards,
Josh
 
My most accurate loads:
55,0gr varget with 130gr ttsx
50,5gr varget with 150gr ttsx
51,5gr imr4064 with 150gr bullet

+1 for 57-58gr imr4350 with 165gr bullet

56,0gr-57,0gr imr4451 with 165 bullet
48,5gr imr4166 with 165gr bullet
49,0gr-50,0gr varget and 168vld bullet
~56gr imr4350 with 180gr partition
 
Last edited:
Back
Top Bottom