50 Beuwolf Metal Magazines PRESALE!!

Status
Not open for further replies.
I was looking on C products website in the USA and do not see a 50 Beowulf magazine offering. Is this something made exclusively for Canada?
 
Maybe someone could make some of those 3D printed mag extensions. Anyone with a 3D printer could probably make a good buck selling those,since a bunch of these mags are being sold
 
Two 10 round LAR15 mags coupled have almost an identical profile to a 30rd magazine, so two of these would make a very, very long magazine.

Once i get these in my hands i'll see about a 3D printed extension if one is so badly needed. I do think these + ranger floor plates, or 3D printed floor plates would work real nice.

I think this just kicked the plastic 50 beowulf mags right in the teeth and put a huge dent in the upcoming 10rd magazines that Alberta Tactical is trying to put out. Man are they kicking themselves for not releasing them sooner.


haun0002 said:
I wonder if you could couple one of these with a LAR 15 magazine? If so I wonder what that would look like. Close ish to a 30rnd mag profile perhaps?
Click to expand...
 
Red_Liner740 said:
Two 10 round LAR15 mags coupled have almost an identical profile to a 30rd magazine, so two of these would make a very, very long magazine.

Once i get these in my hands i'll see about a 3D printed extension if one is so badly needed. I do think these + ranger floor plates, or 3D printed floor plates would work real nice.

I think this just kicked the plastic 50 beowulf mags right in the teeth and put a huge dent in the upcoming 10rd magazines that Alberta Tactical is trying to put out. Man are they kicking themselves for not releasing them sooner.
Click to expand...
it's a pity really they cheap out on the polymer they use, maybe it's too expensive to source good quality polymer in Canada?
 
Familygunnutz said:
it's a pity really they cheap out on the polymer they use, maybe it's too expensive to source good quality polymer in Canada?
Click to expand...
Nope, not tough to source the tough as nails polymer. Its tough (expensive) to source the mould, that will stand up to a high glass fill nylon ;)
Im guessing they went with a 4140, or....ugh....aluminum mold. They made their money, I can assure you, looking at the flash lines on a few of the mags ive seen.
 
Status
Not open for further replies.
Back
Top Bottom