A brand new bolt action 9mm para rifle?
- Thread starter Dark Alley Dan
- Start date
It may not be a SBR in a pistal round but I keep thinking of 12" or 14" barrel in 338 federal and SeeAll sight it would be just a simple barrel swap sumthing like this
I bin looking for a cheep 308 action to make my dream bush rifle
I bin looking for a cheep 308 action to make my dream bush rifle
Last edited:
Mumbles Marble Mouth
CGN Ultra frequent flyer
- Location
- Lower Mainland
It doesn't say its an actual gun. Its just a conversion kit. They have kits to turn a Lee Enfield into a 45acp.
Bolt action,single shots,pump actions and lever actions can all be NR SBR
But the barrel has to manufacture to length you can't cut the barrel down this is not a do it your salf project
I know bits and pieces is a licenc Manacture
This is why I'm looking for a 308 or 243 action then the rest is quite simple order a barrel blank send it to a licence Manacture (but I am after a 338 federal and not 9mm)
It's just a simple barrel swap just don't do the cutting your salf and keep the over all length over 26"
Dark Alley Dan
CGN Ultra frequent flyer
- Location
- Darkest Edmonton
Carverk, I have to wonder about the effectiveness of a .338 fired from such a short tube.
Awesome fireballs, crazy levels of noise, but I have to think you'd be burning a lot of powder outside the confines of the barrel. I'm not trying to poop on your parade or anything, but has anyone else tried this?
Awesome fireballs, crazy levels of noise, but I have to think you'd be burning a lot of powder outside the confines of the barrel. I'm not trying to poop on your parade or anything, but has anyone else tried this?
Magnum research makes a 45-70 revolver...
No you can't cut the barrel blank your salf you have to have a the shorter barrel costom manafacterd for your rifle
You can get a blank and send it to a company that holds a Manafactering license and have them make the barrel for you
This is why the Rossi ranch hand is NR it was Manfacterd that way so it NR but if you cut the barrel your salf. It becomes prohibited so put the hacksaw away
It's to bad that no one is not making a 14" rifled shotgun barrel that would be the perfict bush rifle
T/C makes pistal barrel in 338 federal it won't be for shooting Long range and the recoil will be horrible but it would be handy in the bush and a back up for my ATRS Modern Hunter
I don't know if I coped the link right or not
https://m.youtube.com/watch?v=FJxuakChbfo
Last edited:
Ok if I have to
I know it's a crazy law
There are sum other calibers to look at that would be easy to make a SBR 223 ,243,260,308
Dark Alley Dan
CGN Ultra frequent flyer
- Location
- Darkest Edmonton
Revisiting this necrothread. Has anyone here seen one up north of the Medicine Line?
This sounds like a natural fit for when Ruger resumes production of the 77 rotary rifles. Turning the 77/.357 into a 77/9mm would be a snap and would result in a very cool little toy...especially if they do it up with a 10-inch-or-so barrel.
